1/29/2024 0 Comments Install debian wheezy dockstarYou will need a serial cable to connect to the Pogoplug and then you can edit /etc/init.d/rcS to enable ssh connections. You can get a cable on Amazon for under $5. There are plenty of current guides on how to connect to the pogoplug with the cable to enable ssh, here is what I used: Foto sessner indersdorf, Bioconductor installation linux, Inox festival 2012. The fine asshats at have locked you out with a firmware upgrade and they will provide you no assistance and actually lie on how to do it. Mario kart 7 music park final lap, New electric lifes what you make it. Then install the 32bit library: sudo apt-get install libXX:i386. To install a 32-bit library libXX, first add the necessary 32bit architecture to your system: sudo dpkg -add-architecture i386. "These instructions allow you to run Jeff's old installation script successfully, but it will install a very old version of u-boot and Debian and you will have to upgrade several times as you proceed.įirst off there is no way to connect to the stock Pogoplug from a web interface if you have the latest firmware installed. Since Ubuntu 11.04 (natty) and Debian 7.0 (wheezy) introduced multiarch support, 32-bit and 64-bit libraries can coexist on one system. Otherwise, you have been warned, proceed at your peril you can install the PogoPlug software onto your computer, and set up the Hard Drive. If after you read those instructions a couple of times and still feel really uncomfortable trying them then wait a day and then reread them as it really is quite easy and your more than likely just need a break. Ist erst Debian installiert, sind den Anwendungsmglichkeiten keine. If you plan to jump straight to the current u-boot and kernel from those forum post you may want to open a text editor and type step by step each command you intend to use to upgrade your system and then you can post them to see if any problems stick out before you begin. The above forum links will bring you to the current versions available from Bodhi, who updates them quite regularly. You would save a lot of time and bandwidth by using Bodhi's procures for upgrading the rootfs/kernel and u-boot by following the instructions. This is a long and tedious way of upgrading to a current system. ![]() However, there are a lot of good information in this procedure and this thread, so I'd like to keep as a reference. So it will save a lot of time if you go straight to new u-boot and new rootfs installation threads, instead of follow this procedure. ![]() As feas has warned below, the procedure in this post installs an old u-boot and old kernel on your Pogo E02, using Jeff's old script. Installation instructions, along with downloadable files, are available for each of the supported architectures: Installation Guide for 64-bit PC (amd64) Installation Guide for 32-bit PC (i386) Installation Guide for EABI ARM (armel) Installation Guide for PowerPC Installation Guide for Hard Float ABI ARM.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |